Kenda bear claws on the rear...Great traction, can bust them loose cornering...stretched new DID chain to the point it is now a 98 link!!!!
Carlisle badland fronts(holeshot copies)...good cornering but seem to wear fast.
Piss on the stock lights and install a set of small halogen,xenon ,any fancy **** aftermarket 30-50 watt aftermarket auto lights for 30 bucks. Or spend $100 on some ATV lights with a fancy name...
Gaurenteed that ANY auto aux., or fog lights will be brighter than any stockers.
I would not use a steel wire wheel on aluminum. I use a steel wheel to port out aluminum intakes for vehicles. a "steel" wheel cuts aluminum, leaving an uneven/not flat surface .
Scrape with screwdriver,razor,knife etc. use wd40 for ease of removal too.
A Brass wire wheel could be used for...
Buy a clamp on style filter and get rid of the stock airbox headache. Keeping sand and dust out of the motor is a good way to make your ride last longer...not just go fast.
I would be worried if I didn't have a couple shavings in my oil.
Most of it comes from -gear mesh- of the tranny...or more specifically, the times you blow a shift and grind 'em.
over.
I drilled out a teflon roller to fit over the "stud".
I got the roller at ag. supply store.
I also cut a piece of uhm pipe and use it for a slide around the left ,inside swingarm "pivot" as well...