yfz swinger ?

[Mathius]

yeah im working on that right now

I was just being a smart ass.. lmao
That'll be a lot of work hunting down all those swinger lengths.

 

[bones]

yeah it is .. feel free to help out lol ... its was a huge pain in the ass finding all the widths

 

[Mathius]

yeah it is .. feel free to help out lol ... its was a huge pain in the ass finding all the widths

Sure.. I'll see what I can dig up, and I'll send my findings to you in a PM. :tup:

 

[bones]

added

 

[bones]

so far it looks like the 700r might be a directed bolt on with the addition of a spacer in middle of the pivot just need to find out width from sprocket to rotor

 

[duneracerweston]

Ooo I can help there!! Ill be back in 5 min!

 

[duneracerweston]

9 3/8 inside to inside

 

[bones]

is that on the warrior or 700r and can grab the length off the kfx

 

[duneracerweston]

700, I can give me a while

 

[bones]

hey i kow im pain in ass but my quad is 40 miles away ...need warrior width from sprocket to rotor inside to inside

 

[duneracerweston]

Ill get it too

 

[bones]

you wanna grab one from the ctr of the link mount to the ctr of carrier as well

 

[bones]

drw any luck on those measurements ?

 

[sparkymichigan]

Did anyone finish this build idea?

 

[duneracerweston]

I forgot completely about this.. If I remember ill get those tomorrow when its not cold as a headlocker

 

[buzzy613]

i think bones forgot too lol

 

[Mathius]

Luscombe modded a YFZ swinger to his Warrior.

 

[bones]

havent got a swinger yet try it with

 

[DeadLastRacing]

Luscombe modded a YFZ swinger to his Warrior.

His wasn't stock though, but the info should work. I had asked him to measure the spacers he had to use, hopefully he got to it.

 

[Luscombe]

I'll try to get the measurement tomorrow, but my engine may be a touch right or left of a stock engine. If you are going to use a YFZ swinger just find a bunch of large diameter 5/8" ID washers. Or have some steel spacers made in a few thicknesses and play around until the chain lines up that's all I did.