Bkroll84's Quad. Elite?

Yamaha Raptor 350 & Warrior Forum

Help Support Yamaha Raptor 350 & Warrior Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Guess who just picked up a set of yfz 450 works shocks this guy. Only problem need rebuild and bushings anyone know where I can get them done at? Also got a new carb a 38mm so will have to get drw box and inlet. I got a bonus check from work so im splurging wife will be pissed still have about 460 left what else should I get already took out 250 for westons setup input needed fellas
 
I wanna make a honda killer my buddy has a 400ex so I always get **** from him so I want my warrior to be the best it can be.
 
Problem I had with the yfz was they were sprung way too soft, myself and kyler tried yfzs with aftermarket a arms and we ended up switching. Just an FYI I'm throwing out
 
I know you have done quite a bit since you first posted this.. Shouldnt be a problem just need some new pictures asap before Dean and mods ok it..
 








Chassis | Suspension | Controls
Frame:stock
A Arms:+2 full flight
Swingarm:+1 87 swingarm
Steering Stem:Stock +2 inch tusk bar risers
Stabilizer:n/a
Axle: Durablue x33 +2 +4
Carrier:2nd gen carrier with pivot works bearings
Locknut: Durablue
Hubs F|R:stock/Durablue
Bars:pro Taper
Throttle/Clutch Lever:Stock/R1
Grips:Tag
Nerfs:n/a
Pegs:Ims roll design with tusk ltz400 heel guards
Bumper:prm baja
Grab Bar:AC wide
Front Shocks:Works triple rate for raptor 660
Rear Shock:banshee
Brake Pads:EBC
Brake Lines:stock
Rotors F|R:magnum with yfz450 front/stock rear
Rims F|R:stock
Tires F|R:CST ambush
Plastic:stock cut front fenders
Graphics|Seat Cover:made by me with blue insert
Number Backgrounds:n/a
Handguards:pro Taper
Bar Pad:pro Taper
Fuel Tank:stock with grenade breather tube
Skids plates:AC
Lighting:Led front and rear
Engine|Drive System
Cylinder Head:p&p
Gaskets:tusk
Piston:wiseco
Cam|Valves Springs:stage 2 hotcam kibblewhite springs with wiseco valves
Bore & Stroke:.20 10:25:1 wiseco crank
Displacement:353
Carburetor:38mm round slide carb
Spark plug:NGK irdium
Stator:stock
Shifter:banshee modded for big bear oil cooler
Air Filter|Box:custom air box and tube made by me with a huge uni filter
Header|Silencer: DG full exhaust titanium header wrap
Clutch|Plates|Springs:tusk
Gearing F|R:12/41 Jt sprockets
Chain:EK quadra x ring
CDI|Killswitch:Me if i fall off
Cooling:perma cooler with big bear adapter
Other: skull shock covers ASC chain guide and slide case saver made by me and Im sure theres more.

Bkroll84 couldn't get this up cause he can't get to a computer so there ya go ya bastards!
 
Last edited:
Back
Top