Search results

hey i need the stock needle that comes with the edelbrock carb....i installed the biggest one that came with the carb (19E or 20E i think) and according to my air/fuel mixture gauge im running too rich and need a smaller needle....so anyone with smaller edelbrock needles laying around shoot me a...

hey after getting my intake polished ive noticed that when riding in sixth gear full throttle my engine starts to hesitat and stumble....its not till i back off the throttle and push it in slowly that it will start to run right....top end is stumbling in sixth gear.....i have the biggest needle...

i thought for the amount of power the carb gives you, this was one of easiest mods to do

must have been too much power hahaha.....wish the sproket would have stripped instead of the keys on the shaft....would have made the fix just alittle bit easier

i've found out that the output shaft keys are stripped....ganna have to split the case and put a new one in

ive tripled checked the clutch to make sure everything was adjusted properly...i dont even think the clutch was the problem to begin with because the problem just happened all of a sudden (running the quad one second and then it just quit moving on me)...i can shift gears but there isnt any gear...

well for the last couple of months i thought my clutch was slipping when i shifted into 2nd-6th.....then a week ago my quad just quit moving when i put it into gear....i replaced the clutch and everything is put back together correctly....the problem is i can put the quad in gear and push it...

hope the jackstand doesnt fall out

albas the only place ive ever found the je 10.75:1

acid is fun

just get a degree key from vitos for your flywheel....i think it advances it 4 degrees if im correct

DP should be the best cause it costs $160......on the other hand you could get an EBC for $70.00 on ebay and that comes with stiffer springs and a new clutch cover gasket...thats what i did

hey i know that your not suppose to run amsoil when breaking in a new piston...but in my situation i am in the process of getting a new clutch...if i run amsoil from the start will it mess anything up??..also where is the 4-stroke 20w50?? all i can find in amsoil 4-stroke is 0w40??

very true.....need some pressure on the rings to open them up and allow them to seat properly....after 15 mins rings wont seat properly

nope sorry

just clean the hell out of it inside and out...and post it on ebay and watch the bids come in

i sold mine for 180 on ebay

my eyes

put a crap load of cam grease on it before installing too...this will help with the break in

i just got done selling mine on ebay for $185