Recent content by ba9801

I have the Kibblewhite valves & HD springs with a Wiesco .040 piston. Great combination.

My friend has an 01 and it runs pretty good. I think the suspension on it sucks but besides that it is a pretty good quad. His has all stock suspension on it. The only other problem we had with it is the exhaust studs on the head broke so we had to pull out the engine and drill them out and we...

I will order a new clutch next month and once the parts come in I will pull it apart and file down the groves in the basket. I will let you all know how it works out once it is done. I am going away hunting so that why I wont have time to do any of this till next month. Thanks again for all your...

I will recheck the reverse adjustment tomorrow

yes I have tried to adjust it and the cable is less than a year old so I know it is not stretched as again it does not really get ridden anymore. I remember when I did the clutch last that the basket started to have some light grooving in it so that is why I think it is just getting worse over...

I dont think the oil getting hot is my issue as I can ride it for 10 minutes and it will start to act up. I really don't want to do alot of work to the bike as it is in overall great shape and I don't even ride it anymore. I just want it to be reliable for friends to ride. I know the clutch is...

I am having problems with my clutch and I am pretty sure it is that the clutch basket is worn and the clutches are not disengaging properly. When I put it in reverse with the clutch pulled it still wants to drive away. It is also getting very difficult to find neutral and I am running a direct...

I just worked on a magnum 330 and it took 2 qts of engine oil. I think I work on more Polaris's than any other quads. Honda & Can Am seam to be the most reliable and I see them the least amount. Polaris does not seam to last very long without alot of maintenance. We are always changing axles...

I have a shock relocation bracket on mine and I'm running Honda 400ex shocks that I had left over from my 450R shock conversion on my 400ex. They are a better ride on the warrior as they have more travel. The shock relocation kit I have is from Diamond J Customs. I am also running their a-arm...

Welcome :)

Welcome. Where in PA do you ride?

I have used a small chisel to tap the screws around.

I have had all kinds of problems with my electrical system as well and was also thinking of upgrading to a newer setup. I was looking at some newer wiring harnesses on ebay. If I was to do this what would be the best year setup to get and what all would be needed. I have an 87. I have even gone...

The 89 is kinda a year all its own so make sure the parts are the same for your model. 87-88 use a different frame, a-arms, swing arm, and the lights are mounted in a different spot. The 89 uses the 2nd gen frame but still uses the 1st gen lights. Also the rear brake rotor I believe is only 89...

Many of the pay atv parks have a class 1 limitation which is 50". That is why the RZR is classified as a class 1 at 50" and allowed to run in these areas, all other UTV's are class 2 or class 3. As for width I have the diamond J Customs +6 widening kit on mine as I could not find any a-arms for...