htrods 379 vs cwr 400 vs hicomp 366cc

[Venom]

i see your point man. Its pretty frustrating for me to spend money in parts and dont get the most of it... Any way i was just browsing around and found this
http://barcelos-braga.olx.pt/colaca-warrior-varrior-lol-iid-82951163
it says that its ported and polish. It needs some work valves and stuff, and spark plug threads. what do you think?

 

[jeffsyfm350x]

i see your point man. Its pretty frustrating for me to spend money in parts and dont get the most of it... Any way i was just browsing around and found this
http://barcelos-braga.olx.pt/colaca-warrior-varrior-lol-iid-82951163
it says that its ported and polish. It needs some work valves and stuff, and spark plug threads. what do you think?

Id stay away from someone elses **** you dont know what they have and it might be garbage..

 

['00 WO-YA!]

^+1

 

[beastlywarrior228]

wiseco 10.25-1 or JE 10.5-1 with a web .390 is what id recommend for a setup that leaves the head alone. if you want more low rpm power then do a stage 1 hotcam or a web .413

 

[Venom]

ok guys thanks for all the advice!!

 

[Venom]

Just an updated.
I ve got what i was thinking it was a good deal: for 130 euros ive got a 83.5mm wiseco 10.25:1 complete and new and a cilinder bore and honed and super clean, but the sleeve is missing a little bit on the top...were outside touches the cilinder

 

[Venom]

Here is a pic. Should i run it or bin it? The piston alone would cost me more than what i paid for. If its ruind that ok (sort of....)

So here is an update of my build:
wiseco 357cc 10.25:1 ( without base gasket)
hotcam 1
3 angle valve job ( i was going for +1 but someone said: small dispalcement no head work, nevermind the expence)
some port cleaning, and matching.
And thats it.

 

[duneracerweston]

Id run it. A fresh hone and rings and your ready to rock

 

[Venom]

Thanks a lot man:tup:!! Its already honed and bored ready tho go in!

 

[lbjamm]

Id run it. A fresh hone and rings and your ready to rock

^X2 agreed