wiring harness plugs

[kevinsranger]

what do you guys do to pull the pins from the connectors? i see they sell source coils, and pickup coils, with just bare ends, so how would you swap them over to your connector?

 

[bones]

i cut the wires than solder and heat shrink them

 

[kevinsranger]

i thought about that, but the problem i have now is soldiered wires and broken insulation, so what i wanted to do was slip the pin out of the connector, shrink wrap the length of the wire between the stator and connector and then put the pin back into the connector.

the electrical tape just dont stick to the wiring in the stator case due to being soaked in oil, the oil also makes it a bit(h to soldier nicely