W warrior333 Well-Known Member Joined Jul 28, 2006 Messages 341 Reaction score 0 Apr 15, 2007 #1 my book says that the valves should be set to intake .06-.07 and exhaust to .16-.20 is this right because mine are really noisy
my book says that the valves should be set to intake .06-.07 and exhaust to .16-.20 is this right because mine are really noisy
F flyinacez Well-Known Member Joined Jun 3, 2005 Messages 498 Reaction score 0 Location USA Baby Apr 15, 2007 #2 my book says intake .06 - .10mm or .002 - .004inch exhaust .16 - .20mm or .006 - .008inch Manual is 1987 thru 1999. But, I have used these specs on an 01 and 03 aswell and everything runs fine!
my book says intake .06 - .10mm or .002 - .004inch exhaust .16 - .20mm or .006 - .008inch Manual is 1987 thru 1999. But, I have used these specs on an 01 and 03 aswell and everything runs fine!
0 03warriordad Active Member Joined Apr 9, 2007 Messages 41 Reaction score 0 Apr 16, 2007 #3 .006 or.008 sounds right, .020 is way to loose
W warrior333 Well-Known Member Joined Jul 28, 2006 Messages 341 Reaction score 0 Apr 16, 2007 #4 well im looking at my feeler gauge and it has 2 sets of numbers so on the one that says .006 under that it says .152 then under that it says MM so what do i go by im guessing the top number and it doesnt have inches
well im looking at my feeler gauge and it has 2 sets of numbers so on the one that says .006 under that it says .152 then under that it says MM so what do i go by im guessing the top number and it doesnt have inches
J jasonp Well-Known Member Joined Oct 21, 2006 Messages 2,385 Reaction score 0 Location New Richmond, WI Apr 16, 2007 #5 http://yfm350.proboards31.com/index.cgi?board=tutorials&action=display&thread=1173385110 A couple posts down you'll see the spec for the stock cam... valve lash.. Use MM on your feeler gauge so as it's a little more acurate. (the bottom number)
http://yfm350.proboards31.com/index.cgi?board=tutorials&action=display&thread=1173385110 A couple posts down you'll see the spec for the stock cam... valve lash.. Use MM on your feeler gauge so as it's a little more acurate. (the bottom number)
W warrior333 Well-Known Member Joined Jul 28, 2006 Messages 341 Reaction score 0 Apr 16, 2007 #6 Stock Warrior Cam .341" lift I/E Valve Lash .00236-.00394" I / .00630-.00787" E mine doesnt go that low its .156 on the .006 thing
Stock Warrior Cam .341" lift I/E Valve Lash .00236-.00394" I / .00630-.00787" E mine doesnt go that low its .156 on the .006 thing
J jasonp Well-Known Member Joined Oct 21, 2006 Messages 2,385 Reaction score 0 Location New Richmond, WI Apr 16, 2007 #7 .006" is thousands of an inch. It looks like I have them in inches you can go by that. .002 to .004 on intake. .006" to .008" exhaust.
.006" is thousands of an inch. It looks like I have them in inches you can go by that. .002 to .004 on intake. .006" to .008" exhaust.