Swing arm bolt

[1statv]

Any advice on getting this thing out??? I've been banging it for 3hrs and its out about an inch so far. I can turn it easy with one hand so I don't think it's seized but it just won't slide out

 

[paintslinga2010]

Lots of PB blaster. Some people end up cutting it. Im struggling to get what is left of the bearings out.

 

[88WarriorBoy]

punch and a BFH

 

[1statv]

I'm going to cut the frame on the ends were the bolt goes through and soak in diesel . Spoke to warriorsam he said the bolt might be warped from the frame being bent in the rear. I've been hitting it for hours with wd40 and pb blast no freaking luck smh

 

[1statv]

Alright fellas here's how you get a stubborn swing arm bolt off

1. Center punch 7/16 (11mm)
2. Pb blast let set for a while
3. 5lbs hammer
4. Good meal before start
5. Build some anger
6. Pound the Mf'er out trust me follow these steps and you will be satisfied

 

[beastlywarrior228]

I've had to cut mine out, it's seized into the inner sleeve

 

[1statv]

Does anybody know if the Carrier bolts are suppose to have these 2 washer on them ?? For both bolts upper and lower

 

[beastlywarrior228]

That's fine it's a lock washer

 

[1statv]

Cool