PineyPower
Well-Known Member
Hey everyone, got a quick mod that helps keep your feet planted on the oem pegs.
You'll need a cut off wheel (or similar) and a small adjustable wrench or good pliers.
Step 1: cut straight down on the top of each point of the pegs. Your cut should be about 1/4 deep
Step 2:bend your newly cut tabs slightly, alternating between bending toward and away from the center line of the peg. The edges of your tabs should be even and just about touching
That's it. There's no more steps.
You'll need a cut off wheel (or similar) and a small adjustable wrench or good pliers.
Step 1: cut straight down on the top of each point of the pegs. Your cut should be about 1/4 deep
Step 2:bend your newly cut tabs slightly, alternating between bending toward and away from the center line of the peg. The edges of your tabs should be even and just about touching
That's it. There's no more steps.