carb kit

Yamaha Raptor 350 & Warrior Forum

Help Support Yamaha Raptor 350 & Warrior Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

3ffreak

Member
Joined
May 25, 2008
Messages
8
Reaction score
0
Location
Northern Ont
Hey there. ok I added a DG slip on pipe, K&N air filter and a Dynojet kit for the carb. My problem is I can't find the air idle mix screw. It says in the kit to turn itin then back it out 2 turns. Where they show it in the pic it looks like it's solid brass??? Thanks in advance for any help and enjoy the ride :)
 
You need to drill out that plug. The mixture screw is directly below that brass plug. I bored the plug out with a 1/4" bit (if I remember correctly) until I able to pry the plug out with a screw driver. Hope that helps.
 
try and find the factory specs, it might already be at 2 turns and you wouldn't have to drill
 
Back
Top