ACA332
Active Member
- Joined
- Oct 9, 2011
- Messages
- 38
- Reaction score
- 0
A while back, I bought an aftermarket rear axle from ebay. Nice and solid, much thicker than stock. The bolts that hold the wheel hubs on are much bigger, with a much coarser thread than the factory ones.
Problem is, I can torque them to 120 ft lbs, install a cotter pin, go for a rip and when I get back, if I pull that pin back out I can sometimes spin the axle nut off by hand.
How much can I torque these guys? I can't find any info online for the axle. Is thread locker a better idea?
Problem is, I can torque them to 120 ft lbs, install a cotter pin, go for a rip and when I get back, if I pull that pin back out I can sometimes spin the axle nut off by hand.
How much can I torque these guys? I can't find any info online for the axle. Is thread locker a better idea?