Frankenstein's-warrior
Active Member
Hey all, my name explains my warrior. Basically atm I have a 90-95 electrical system(I think). Stator wires match that year gap. I was proving and ohm'ing the stator since I'm still not getting any spark after a new cdi. This is with a new coil, harness, start/kill switch. My readings for white wires were all within 0.7-0.8 and no continuity to ground. My red and white was 425. My Brown and Green produced around 2.6. not sure why one read 2 and other 400. That's on the same setting on my fluke. I have looked around a bit but didn't find one specifically for what I'm looking for. Any helps appreciated.
