1st ride, big disappointment

Yamaha Raptor 350 & Warrior Forum

Help Support Yamaha Raptor 350 & Warrior Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
new sprockets and gold series o ring chain, properly adjusted. The carb is the main issue I believe, Ive jetted every which way, moved the needle all around, and no matter how close I get it, the biggest issue Im dealong with now is once I let off the throttle and slow down and get back on it, it laggs. When I adjust everything to get the lag out, it runs like crap every where else, so I went ahead and ordered up a carb, just waiting for it to arrive and then see what happens
 
I was going to go with the edelbrock, but then cheaped out and went with a raptor 350 carb ($35 shipped with throttle cable), I have to buy an intake yet as well, everything Ive read claims the throttle response is better and my warrior needs that and hopefully it helps the problem altogether, only time will tell, should have everything here in a week or so
 
if you have a stock carb... try a #45 pilot a 157.5 main (pending your elevation) im from ohio.. 2.25 turns out on your fuel screw make sure idle is good and check the tension on your timing chain because if whoever built your engine used the stock chain with the piston and cam... its probably stretched like a pornstar so check that out as well
 
Back
Top