Hey yall,
I picked up an old (but in very new shape) Craftsman 45" snow blower attachment from some guy for $100 near me. I welded a 3/4" shaft with two pieces of 1/8" plate steel to the bottom to allow it to pivot 30 degrees left and right allowing it to always settle on the ground on any...
Hello,
Just posting this clip I had of this terrible "engine" rattle I encountered mid ride a few weeks ago. This has already been fixed a few days ago but it might be helpful to someone with the same problem. I had the quad down to the bare frame over the winter time and when I put the engine...
You are very lucky to have a 99. 1997 to 2001 were (to my knowledge) the mass-produced years of the warrior 350. You might be better just replacing the harness. Im sure someone on facebook marketplace has one for under $100. No more headaches! haha.
Hello,
Stock engine, stock bore, Supertrapp II exhaust with no discs (completely open). What would be a fair starting point for a jet? I'm running 145/42.5 and it sounds like it's running okay. My neighbors don't appreciate the sound as much as I do around here so I'm planning a ride in a few...
There were I believe 7 generations of this quad. You would need to list the year to be more specific on which CDI. These quads had very minimal wiring on them to begin with so you most likely need every wire. Why would you remove wires? Seems silly to me.
Hello all!
I picked up a 1987 Warrior 350 for very cheap. It had roughly 50 hours on it when purchased but it sat for a long time under a tree with a tarp.
Runs great, top end/lower sound, replaced every seal bushing and gasket on the engine/frame. I ran into an issue with this specific model...