Recent content by jccuiser78

Hurt my back-have to sell for $2000 firm.I will ship on your dime.I am in Marina,Ca.93933.I havent rode it since November. Yamaha Warrior YFM350 1987 Yamaha Warrior. 4 stroke,6 speed manual 350 cc,electric start,pull backup.New battery and solenoid.All wires gone over.Quad was completely...

Details: 1987 YFM 350 rebuilt motor,stock bore Dirt digger clutch Pull start backup Alum air box,Uni filter,jetted Rebuilt carb-stock New battery New starter solenoid kill switch(not wired ::) YFZ450 front shocks-with correct conversion bracket(see post) 01 Raptor rear shock Newer...

I hate to see it go,I serious back problems and a new baby,I have not ridden it since last year.Look up my posts to check it out or pm me IF SERIOUS.I am in central ca. $2300,will ship.Runs perfect and very low hours since complete overhaul

Good stuff-I have the levers ;D

Looking good!

Basically,yes--allthough you will need to use your stock needle.The jets are the same

Fun,yeah

I got mine for $100 used on e-bay.It should? work with a rap350

I would say it helped-and was worth the money

It flows out of the discs.kind of like a circle

Yep

This is my 87-46.5 inches wide(wide enough for me)stock a-arms,1.5" spacers

All stock,new rollers and it works fine for me,some have problems keeping the chain tight.

I have it pretty soft-10 clicks out on rebound and about half of compression,I am 200 lbs.It depends on how you ride(jumps and whoops)I would start at soft first,then go the other way.Just my opinion.