Ya that's the only reading I get across ANY combination of terminals on that plug.
So I'm thinking just buy a new stator and pickup coil and replace it all together? (That includes the source coil correct?)
Well I just ohmd out my coils using this
The primary circut was lower then the specs and the secondary circut was a lot higher then the spec.
I couldn't get a reading at all using one meter on the secondary circut. Had to switch meters. I don't know what if anything that could mean. First...
So thought I had this quad ready to ride. Went out to start it and no spark. Nothing at all. I looked up the service manual about testing the stator. Here is the plug im working with.
So it says to test the source cool to meter the Red and white/green wires. I get nothing. Open circut...
If some could verify for me. Motor turns counter clockwise (looking at it from the flywheel side).
I pulled the cover and clicked the starter. Stated turns, idler gear turns, gear behind the flywheel turns but flywheel doesn't. Guess the bearing is junk. Waiting on the flywheel puller to show...
Just purchased a 2002 warrior. Has an issue starting. I've searched around but haven't found an exact answer to help me figure out exactly what the issue is. Starter itself was replaced last year. It works, you can hear it spinning. I even pulled the side cover and verified yes it's turning...
Pulled the carb again and it was clean still. Although i still blew sum air threw it.
And there was a problem with the throttle cable sticking. Got it all ironed out but still have slight hesitation stumble at easy 0-1/4 throttle. Gonna mess with the fuel screw to try and fix it.
gas valve was clogged up so it wasnt getting fuel!
Got it started but it idles really high and has a pop. Doesnt seem like the idle screw does anything so I have to look in to that too. Its to cold outside to mess with it now but I might go back out in a little bit and pull the plug and see...
Ok really stupid question....how do you adjust the float height on this thing? I dont remember seeing an adjustment for it?
I'll have to go look at it again after work tonight.
And I tried taking the filter off already...no change
Thanks guys!
Did have time to check the timing but the only thing I changed was a 143.5 (?) jet to a 150. Changed the oil filter. Changed clutch cover gasket. Filled with amsoil. Installed new oiled uni air filter clean the heck outta the air box drilled holes in air box.
That's it. I did noticed that I...