kylemm1002
Active Member
So thought I had this quad ready to ride. Went out to start it and no spark. Nothing at all. I looked up the service manual about testing the stator. Here is the plug im working with.
So it says to test the source cool to meter the Red and white/green wires. I get nothing. Open circut between this connectors.
The thing I'm questioning is it shows the pins should be diagonal each other and mine are on top of each other.
Next it says to ohm the yellow and blue wires...well I'm either totally missing something because I see no yellow wire on this connector.
For reference this is what I'm going off.
I really hope I'm missing something because this is driving me nuts. I did have to replace my starter bearing a few weeks ago and deleted my parking brake. But I did ride the quad after those mods were done.
Please point me in the right direction!
So it says to test the source cool to meter the Red and white/green wires. I get nothing. Open circut between this connectors.
The thing I'm questioning is it shows the pins should be diagonal each other and mine are on top of each other.
Next it says to ohm the yellow and blue wires...well I'm either totally missing something because I see no yellow wire on this connector.
For reference this is what I'm going off.
I really hope I'm missing something because this is driving me nuts. I did have to replace my starter bearing a few weeks ago and deleted my parking brake. But I did ride the quad after those mods were done.
Please point me in the right direction!