Search results

Or you could save a lot less pennies and buy the artraxx Tires for your rims if you put 21" up front and 20" out back it will sit real nice and you will have 4 brand new tires for $200 or less!

Those are for a 10" rim stock warrior rims are 9" when you look at tire size the first number is the diameter of the entire tire from ground to top of tire, the second number is the width of the tire, the third is the rim size! You can change from 22 to 20 as long as they are both for a 9" rim...

I was thinkin more along the lines of a **** lever with the clutch lever attached to it, that would come up near the side of the gas tank!

Ripped a wheelie and crashed and burned off the back of the seat! Quad is fine I got some grass stains!

top speed is prolly some where between................holy **** and hold the f@#k on!

I bought mine here at www.motosport.com

If you are handy with wiring you can drill a hole in the back of your headlight housing and insert a blue l.e.d. wire that to your low beams then wire the regular bulbs to the high beam. You will get a similar affect! I will be doing this as soon as I get my hands on the l.e.d.s

Ah you'll be ok!

Just cut you lid into that shape or use a piece of plexiglass and cut it to a similar shape

I have a size 13 shoe so its fine for me, but guys with smaller feet may have an issue!

Yeah I did it today took me about 15 minutes prolly don't have to lift it up, you could prolly jus lay under it but lifting it was just as easy!

Oh I meant like a big knarley over exxagerated shifter from the footpeg like two feet above my head

Also make sure the fuse is good on the back there by the solenoid!

When hooking the ground to the frame it has to be bare metal or you won't get a ground

Why do you have to take your nerfs off to install a sifter??? Just un-bolt the piece the goes on the shifter shaft splines, take a long screwdriver and slide it off the splines then take the quad stand it up on the rear bumper, get another screwdriver pop the e-clip off the back of the foot peg...

Man that one looks long! It may be the angle of the pic, but that is soo much nicer than the sloppy ass linkage crap setup that was there! If I didn't use my quad to ride, and it was just a toy I would rig up a hand shifter for it!

Just to let you know my solenoid was bad and even with jumpers hooked to my battery from my diesel pickup I had to have the cummins running on high idle to jump solenoid and get it to turn over the motor! I would first change the solenoid and give it a try! I think mine cost me like 40 bucks for...

I just bought an msr shifter for a yz250 bolted right on no modding no fuss! Only thing if you have small feet it may be just a bit far forward, I wear a size 13 boot so its a good fit for me!:tup:

Bolted a msr aluminium shifter up to get rid of that sloppy hoe linkage setup! $25 well spent no modding! For a yz250!:atv:

Oh yeah me either I usally patch them but your prolly gonna end up spending close to the same amount for 4 used tires and you could buy 4 new ones that haven't been through someone elses abuse! Roger!