Recent content by blake22

where are you located in texas dennis? Im south of Fort Worth. Maybe we could ride?

I wish I could find a whole bb 400 motor! I found a used crank decently priced. im prolly just going to replace the crank for now and maybe an over sized high compression piston with the big bear gears. it has enough power now it just doesn't hardly want to take off till about 2000 rpm. I might...

Another post stating that you can swap the motor. more about swapping gears though. might end up going this route... http://forum.highlifter.com/tm.aspx?m=3086543&high=wolverine+350+gear+ratio

link where someone made it fit. http://www.wolverinecentral.com/forums/showthread.php?t=151 I just wonder if all the big bear 400cc motors are the same? can I use just a bottom end from a 400cc with my 350 top end?

from everything I read, people say the big bear 400 bolts right in except one of motor mount bolts needs the bracket moved or hole made bigger

My ol 350 is knocking on my 03. Going to either put a crank and rod in it soon or do a 400 big bear motor swap. Looking for more info. Ive read and talked to a few people and they say a 400 will bolt right in. What years will work? I need the whole motor right? my top end wont work because of...

Ive got an 03 wolvy FMF slip on and UNI air filter. Was running a 154 main jet with the needle on the second groove from the top. I now added a 1 1/2 inch pvc snorkel and it ran lean so I moved to the 4th notch from the top on the needle. seems to be running pretty good. best power its had...

Might have a crack in the intake boot. I had one and it had the same symptoms.

Well for anyone who might read this... I finally fixed it. After having the carb apart about 50 times I was holding the slide and pulled on the rubber diaphragm. I noticed that it spun. The rubber part is smashed between two round rubber pieces and they were loose causing vacuum to leak thru the...

Bought this 2003 wolvy a few days ago and it was really lacking power. no bottom end at all. Guy I bought it from had 27" laws on it. so I swaped them for some 25s and this helped but only a little. Found that the accelerator pump slide is not moving. I can manually move the slide up and down...