Recent content by Bigbuck

Just wondering if you ever clean your Oil Strainer? The 450's seem to have a bolt on the bottom to remove and clean. The 350's seem to be right inside the engine.

I guess nobody else ha either. it's on page 3-26 of the factory service manual if anyone has it.

Anybody do this? This is from the service manual but no mension of it in the owners maual... 13.Check:
Engine oil pressure *****************************************************
Slightly loosen the oil gallery bolt 1.
Start the engine and keep it idling until engine oil starts...

Can someone please tell me the torque spec for the rear hub nut, and also the wheel lug nuts for a 2007 350. Thanks muchly.

Ya it seems to come and go.I Asked the mechanic at the dealership about it. He said water could be getting in through the drum brake seals, or it could just be condensation building up in the axle shaft housing. He said some guys will drill holes in the bottom of the axle shaft housing to drain...

nobody has ever had this issue??

Does anyone know does an 07 wolverine 350 have an engine oil bleed screw to bleed the air out of the oil cooler and oil lines, after you change the oil and filter. Doesn't say anything in the maual from what i can see, but for my 07 ttr 230 it has one. Thanks

Ya mine actually will have a drop or so of oil hanging there after a day of riding. Doesn't seem to bad yet.

Noticed a little seepage on the floor, on the left side of the diff where the axle shaft housing mounts to the diff. Looks like water and a little gear oil. Mainly water,about a Tbl. spoon worth on the garage floor, I can ride for hours and the fluid level never really changes, and never any...

Anybody else?

It's an 07 350 2x4. Ya i have my idle pretty low to. Tried adjusting the linkage but that didn't help at all. Anyone else care to comment on this. It would be much appriciated!:???:

If in neutral, when I put it in forward or reverse, it takes a few seconds to engage, and I have to "feather" the gas to get it to engage. Basically get the belt to spin then it engages. Is this normal?? The sift is smooth and the appropriate lights come on instantly. The same question was post...

Hi Teak, I also posted a similar question about the fan cycling on and off..It's the Newbe with the 07 post.. Got a few replies mainly saying its normal as long as it doesn,t continuosly run and the overheat light doesn't come on when running. It should flash on when turning over to start just...

Have an 07 350 with about 30 hrs on it and the valves have never been check. Was going to take it to the dealership on Wednesday but it looks so easy, there's a very good how to vid on youtube and it's the same year as my quad. Only thing is, nowhere does he ever use a torque wrench. My question...

Thanks very much for the replys guys.