Recent content by yzdude250f

I have a few parts left from a warrior i built up and sold, Please make reasonable offers and i will accept checks or money orders as i dont have a pay pal account sorry I live in Hamilton, OH Im willing to ship so please factor shipping into your offers I have one upper left a arm off an 87-88...

Please do im interested myself.

I'd like info on putting an fcr on the warrior too, what are you guys doing about the tps these carbs have.

i used one and my quad has no issues.

Im sure others will chime in but its best to start rich and work your way leaner, im at 155 main and 45 pilot i was recommended these number by a few people on this site.

bump to the top i got a new bottom end with good trans gears and cases im picking up for 125.00 i want to put a new crank in it, do crank kits come with bearings and is the cam chain side bearing already installed, i know i need a flywheel puller my buddy has one i can borrow and i have the...

These look great ,good work btw, i will pick one up in a few weeks once i get my motor back together have you made one for 14t yet i may go to a 20in tire set up and re gear to a 14t. And i would have mine stamped "round 2" as an inside joke, first time i built my motor the case was busted and...

Yeah it started as in intermitent noise that would go away with some rpm in first now it skips and chatters in first and second like its jumping teeth.

Pm me a price and details.

shouldn't be to difficult then, I'm curious to see what came apart down there might tackle this project a little sooner than i thought now.

I have a local guy selling me a trans gear set he just replied to my email or i would take that offer, so basically take the left and right side accessories off (clutch rotor balance shaft gears starter gears etc and loosen the case bolts flip it over to the right hand side and pull apart, only...

Alright thanks for clearing that up hell i don't think i would notice much with it any way, already have cam port work valves port and polish and high comp piston i will just hop on my yz250 if i feel the need for a thrill. my crank side toside play was in spec when i checked with feeler gauges...

Well earlier this spring i finished my warrior top end build its listed in my signature below, i had a gear noise in first ect well it progressed slowly and now it sounds like a manual trans with wore out synchronizers and skips and chatters under load i have replaced the clutch that not the...

I can agree with the post above i have a high comp piston and i tap the button and it fires first hit every time., Maybe the starter is shot like suggested, does it quit spinning or what? another suggestion is maybe your starter clutch is weak.

My clymer books says 6 ft.lb of torque