Recent content by xbassman

Makes complete sense as the small hose from my rear is also just hanging loose. Tnx for the information. Dennis in Texas

My 2001 Wolverine has a similar problem. When it idles it will pop which causes the carb to shutter. I can hold the carb and feel the popping! I also pops when decelerating. Was told to check out the air vent cut off which in my carb is located on the very top, rubber diaphram looking thing...

When I removed the Mikuni BST for cleaning I noticed a rubber tube connected to a nipple located just above the gas inlet nipple and near the rear barrel of the carb. Hope to post a photo but the above description pretty much tell you where it is.....anyway, this rubber tube attached to the...

It is in addition to rusty tools and will eat alumin. alive. Solved my problem....found some navel jelly and it cleaned up my surface rust problem and it also etches the metal.

My 2001 350 4x4 Wolverine spent some of its life on the Gulf Coast and due to high salt area some of my exposed steel lines on the engine have slight "surface" rust. Would muratic acid - a light coat - then flush with lots of water be a good way to remove the surface rust? Is there a better...

I might be interested in the shifter assuming you have all the installation hardware. Let me know. [email protected]

Can you send me a photo? [email protected]

I know the Wolverine I have is a "sport/utility" type but I sure wish I could find a pair of floorboards or footrests. I am thinking more of the passenger to have a place to rest his/her feet. I can deal with the pegs but a flat surface would be nice. If there is such a thing they would have...