Recent content by teamyardsale

Very possible.

http://cgi.ebay.com/ebaymotors/Yamaha-Warrior-Foot-Gaurds-made-from-050-aluminum_W0QQitemZ230214665920QQcmdZViewItem?hash=item230214665920

For the riding I do I need taller bars. I too ride snowmobile and need on average 4-6" of rise to be able to jump and carve. I mainly just fart around in our pits, wheelie small jumps and stuff, Where taller bars are needed so I dont cramp my back. I really dont notice that much of a...

I have 20" GBC mudsharks, I can go as far as my moms sportsman when shes in 4x4 sometimes

Im almost positive thats a member on this site, he had a few months fof or something, and his neighbor made him a bet he couldnt do it, its only a few pages back I believe, theres pictures too. cost him very little.

Think of it this way, bore it out 2mm (366 kit), put a .430 cam and a high comp piston, and its even better than new.

The raptor bars a 143 mm High, 1 mm = 0.0393700787 inch 143x.0393700787 = 5.62" Youll be fine, I have a 1" riser ontop of my moose bars, most cables have enough slack for 2-3" and then you can still re-route cables for another inch or so.

have you though of finding a straighter (or perfectly straight) bar and then going with the rox 5.5 pivot riser? I have a set of moose bars on mine and a 1" block riser. If I had the time and money I would try and find a straight bar and go with those risers its completely articulating. I...

It's on my Favorites for my Birthday parts. Nitrous, sweeeet.

http://cgi.ebay.com/ebaymotors/Mod-Quad-billet-Yamaha-Raptor-660-660r-BLUE-case-saver_W0QQcmdZViewItemQQcategoryZ43977QQihZ016QQitemZ260211420509QQrdZ1QQsspagenameZWDVW for a raptor

I've seen a few race bikes with them, personally, I like/keep my rims clean enough and shiny so I want to show them off.

What do you do? water and scrub, with all the elbow grease or gthrow the gallon on and spray off? What about a presure washer? just to the block/case and not carb area.

I wish aerodyne (I think its aerodyne) made turbo's for the warrior.

^^No way in hell im paying 60 bucks for it though. Theres billet polished ones for less than that.