I got it. When I swapped the new one way onto the flywheel, the new bearing had the hub piece where the sprag goes installed backwards. Causing the sprag to bite in the opposite direction. I took it off, flipped it over and she fires right up.
Man. I haven’t put much thought into this since it happened. My 15 year master tech experience is slapping the crap out of me right now. I didn’t unhook the battery when I pull the stator housing off. I would think I likely fried it. I never disconnected it from the harness so she would have had...
I’ve taken it back down twice now. When I pull the assembly off the crank, the gear works fine in my hand. Locks when turned to the right or clockwise. When installed just spins over. Everything is meshed and seats just fine on the crank. Now I did remove an OEM part and put in a fleabay one way...
I’ve been restoring this bike over time. I knew the one way bearing was going bad as it would only intermittently engage. I tore it all down and replaced the one way assembly. I dunked assembly in oil and installed. I did clean and dry the tapered portion to get a good seat. Once all back...
Still not content with it. I’ve now put an entire carb rebuild kit in piece by piece. No change. I guess I’ll revisit my timing and valve lash.
Seems to crank for 5 seconds or so on first start. Used to be less than a second. If I touch the choke even the smallest bit, it will stall. Also...
I cleaned it out and put it back together. Same rich idle condition. I will replace the plug and if it ain’t no better I’m just gonna buy a different carb I guess.
I tore it down tonight. But before I took the carb off, while I still had the fuel tank in place, I set up a spot light to see down the throat and started it up. (Another thing, it’s harder starting since this started. It would fire off instantly before) I could see fuel coming up around the...
Hey y’all. First post here.
I bought an 01 warrior. A pure nostalgia purchase. Got it cheap and knew it had problems. I put a new top end and new carb on it and changed the oil. It’s been running great.
I adjusted the valves for peace of mind and then test drove it. It was fine.
My son messed...