Recent content by NFryan

Thanks! I will check it out. Just glad everything is working again!

So I finally got everything timed correctly and reassemble.. My compression at WOT was 180. so Im assuming I have a high compression piston.. I was able to get it to fire over and run as well. So far everything seems to be OK no damage done..

Also found that 2 washers are missing (4 and 7) Which probably made my issues worse or occur in the first place.

Thanks for the quick responses and info guys. I Did do a compression test before discovering the flywheel spun and it said 80psi. But I also changed the timing at that point and it is not currently correct. So It may not be reflecting an accurate reading. I ordered the starter bearing and will...

So got the flywheel puller, and my worst suspicions confirmed.. Woodruff key snapped due to the starter clutch bearing basically falling apart. So I have the woodruff key and starter bearing on order.. I have a question about reassembly.. 1)How does the flywheel go back on .. Just line it up...

Is it fairly common for these woodruff keys to snap? If not what was probably the cause for it to snap and how should I properly repair it to avoid it happening again.

So Im currently waiting on a flywheel puller. When I line up the T on the flywheel with the mark on the case. My piston is not at TDC and my timing is off by 45 degrees. I found TDC by removing my spark plug and putting a thin screw driver down the spark plug hole and cranking slowly by hand...

Thanks for the response man. I just checked it now. That boot appears to be the only new part on the quad and it looks good. The boot was off the air on side a bit though. She still won't fire. Just watched a video on checking the timing. I'm going to check that next. As long as that is good...

I have spent countless hours searching forums on the issues. Just to realize not many people have come back and posted the solution. I was driving a warrior I just purchased cheap (1996) around. Out of nowhere the idle started getting rough, then the engine would hardly rev anymore. I limped...

* Or looking to buy a stock exhaust for a 96 warrior if anyone has one available. This Cobra exhaust is way too loud.

Looking for a stock exhaust for a 96 warrior.

Looking to trade for a stock exhaust pipe.