Recent content by Jaxom

I added a little tab to the outside end of both pegs. Not much, tack welded a nut to the inside of the tab and screwed from the outside inwards. Works great. Close up of tab.

Hee...Hee...Hee If I'm on a major trip I use this little ol' thing: 8-10 quads if I really have to. If I need to I can move the vise to my truck's receiver: Makes for a nice garage too! I added a platform so I don't have to spin the bikes crosswise. Much easier now, just watch your...

2 questions: Why do you use that drain plug? There is a different one just to the rear of that one on my '06 Wolv. Perhaps it's different on yours!?!?! I do use the one shown sometimes if I haven't cleaned the screen in a while. Otherwise I just use the one in the back. It's easier without the...

Just checkin' in. Hows the engine swap working out for you?

I find this amusing. Lots of 700 Grizz owners, myself included, are going to a combination of 4 - 450 Kodiak along w/ 4 - 660 Grizzly weights. That gives more grunt on low end w/ bigger tires and/or higher elevation. Dalton makes a kit for the 700 that is basically this same thing...only...

Take that extra set w/ you on the ride. You might need to change it mid-trip!

Sometimes my thumb just slips off the little yellow button and it doesn't shift in or out! :badgrin: HAH!!!

I really like the GYTR one. I did open up the sides a little so I could grab onto it and drag it around if needed. On the '06 there is no fender supports and the GYTR takes up no more room than stock. I ordered mine from 95Wolverine...Thanks again Robert.

Great idea, 95Wolverine. I am putting on my shoes now (on my feet, not on the bike) and will try your idea of a slight counter sink to the pads' backing plate.

Just wondering if you need a "high temperature" grease on the slide pins??? I just replaced the rears w/ the Tusk carbon one today. I didn't have any high temp grease around so just used lithium grease. Also I sprayed the slide pins with a dry lube first before the lithium. I won't have...

Robert; Are you going to the Pig Roast?

I would try Depends!!!

Yes indeed! Very nicely done!

http://forums.atvconnection.com/messageview.cfm?catid=13&threadid=513935

I wish I had a 35 Hundred CC machine!!! Don't ya just love typographical errors??? :lol: