While I was working on my quad this week I had it tipped on it's side and noticed that I have a lot of play on the rear hubs. Is there anything more you can do to those other then tightening the king nut up or am I going to have replace the hubs. If I have to replace them where do guys go for your parts like that. I've check ebay and they are on there used but I'm not sure I'd be buying hubs that are any better then what I already have. What do you guys think?
Rear hubs
- Thread starter gy67
- Start date
Help Support Yamaha Raptor 350 & Warrior Forum:
warriorkid23
Well-Known Member
just take out the cotter pin and then tighten up the big nut and then replace the cotter pin.
duneracerweston
Well-Known Member
If they are so bad that they won't tighten id get a durablue set of hubs they are alum with a steal sleave so they won't wearout as quick
elwood
Well-Known Member
do you have the washer plate behind the casle nut?
