Raptor warrior clutch mod

[Predator13]

I am ordering the parts for this mod can I use any of the parts from my old set up to use with the new set up also do I need to drill the case on my warrior and what size drill bit should I use if I do thanks


Sent from my iPhone using Tapatalk

 

[lbjamm]

You can use the Warrior arm and spring. Just flip the arm over. You don't need to drill. There is a hole in a casting block on top of the motor under the carb.

 

[Predator13]

Do I need a different clutch cable?


Sent from my iPhone using Tapatalk

 

[lbjamm]

Yes. Did you read the stickie thread?

 

[lbjamm]

http://www.yfm350.com/forums/showthread.php?t=20450

 

[Predator13]

Sorry didn't see that one question is the lever still in between the two marks on the case it's hard to tell in the pics


Sent from my iPhone using Tapatalk

 

[hammy7734]

no you have to move it like 90˚ i think but i have a question could you use the warrior cable or do you need the raptor cable

 

[Warrior1996]

You have to use the raptor cable and cable bracket. You can use the warrior clutch arm, just flipped upside down and clocked towards the rear of the bike.

 

[hammy7734]

ok could i use a motion pro cablde

 

[Warrior1996]

Yup, that's what I have. Raptor 350 Motion Pro Cable.

 

[hammy7734]

ok when i have some money i will do this mod