Camshaft from duncan racing? www.duncanracing.com

[glass11racn]

Anyone used their cams before? here is the specs.

X1 Grind Camshaft
Part #: MC-3350-X1B (Billet), MC-3350-X1H (Hardfaced)
Specifications: Midrange-Top End Cam, Lift: .450", Duration 276
Thanks Chip

 

[whitebros87]

Seems like it could work well.

 

[glass11racn]

bump it up

 

[yeoldetymewarrior8]

seems like that shits gonna have powerband with that much duration

 

[xj4m3]

I have the X-1 billet cam in my warrior. I bought it off of ebay for about 120$. It pulls like no other from about 1/4 throttle on up but below that it killed my lowend. I can live with the lowend though because i got a huge boost in my topend. It seems to rev higher and faster than before and it doesnt have that flat spot in the topend that the warriors are notorious for. I would definatly reccomend it from what ive seen but its quite pricey i believe.

 

[baja226sport]

Sounds like that cam would like to rev alot!!! Maybe to much for trail riding. Don't know what kind of riding you do though.

 

[glass11racn]

I do a lot of trail riding and usually on it pretty hard. Thanks for your input Chip

 

[xj4m3]

If you do slow riding in the woods or something, your definatly going to need to gear down because it was quite hard on the low end. Anything above a 1/4 throttle though and you should be fine.