i just bought a 99 warrior and it needed back brakes. when i was changing the pads the piston wouldn't go back all the way into the caliper. so i started messing with the e brake bolt and then the piston went all the way in. got the brakes on but now it wont roll... the brakes are too tight, i really don't know much about atv's so not sure what's going on? can i just take off the e brake? it has a rubber plunger that goes into the caliper, is that what i would take off and put a block off plate on? would this loosen up my brakes?
back brake issues
- Thread starter j5
- Start date
