04Fivefour
Well-Known Member
Anybody have any recommendations on what to get for stock a-arms? Just don't know what is best, Polyurethane? rubber? brass?
Any input is appreciated.
Any input is appreciated.
A-arm Bushings
- Thread starter 04Fivefour
- Start date
Help Support Yamaha Raptor 350 & Warrior Forum:
Beastmode17
Well-Known Member
TM Designworks are top notch and so are GT Thunders, Heres a pic of the TM Designworks, Had them in a 450 and a 660 and they lasted the entire time I owned the 450. They also have a 2 year free replacement. Outlast bronze 8 to 1, and 15 to 35% more contact area, Both Tm's and GT thunder are no stik self lubricating.
04Fivefour
Well-Known Member
Thats what I was looking for, something not affected by dirt.
04Fivefour
Well-Known Member
found a set on ebay for 38 bucks
Beastmode17
Well-Known Member
38 bucks is a good deal!! They normally go for 65 and 70, Nice find you wont regret buying them.
are those bushings for the upper or lower a arms?
i have play in the upper a arms of my warrior. i thought there was just bushings in there but i see pivot works makes a bearing kit for the upper a arms. has anyone tried that? is it needed?
i have play in the upper a arms of my warrior. i thought there was just bushings in there but i see pivot works makes a bearing kit for the upper a arms. has anyone tried that? is it needed?
Beastmode17
Well-Known Member
The TM Designworks I got do upper and lower a arms. If you ride hard trails and beat on your quad these bushings are what you want, They will last I promise.
