Search results

Thanks a bunch guys!!! Charlie

I am not home right now to take a pic..... But if it is a second gen will the raptor arms fit? Charlie

They are mounted by the handlebars and are square not round....

The part numbers for the 1987-88 arms are different then the ones for the 1989 and after so I think it really is a second gen. Charlie

Also.... 2004 Warrior Left Lower Arm 3GD-23570-00-P0.... If this helps.... Charlie

Like the title says I popped both lower ball joints on my 1989 warrior and have been looking for used arms. Do the raptor 350 arms fit? The part numbers look almost the same... 1989 Left Lower Arm 3GD-23570-00-35 2004 Left Lower Arm 3GD-23570-10-00 I have read that the -00- is the revision...

oops.... 250 lbs or so...not too light I know but this thing dives bad. I did swap them out with another set of Banshee shocks and it is the same, so i guess the shocks are working okay because they feel fine on my banshee. I'll have to give them a shot in the trails then decide if I am going...

250

I just added a set of Banshee shocks I got off ebay and they seem like they are really soft....I know from reading on here that they are softer but this seems excessively soft.... When I bounce up and down on like I am riding it the front seems to "dive" more than the back, kinda like its...

I know this is an old listing but...... I have some factory wheels with worn tires from my Warrior available in Jupiter Florida....Where are you in south Florida? Charlie

Sunny Jupiter, Florida..........

Mechanical Engineer for General Electric gas turbine for energy production presently. Was Pratt and Whitney military jet engine designer in Jupiter Florida for F15, F16, F22 Raptor and JSF Strike Fighter now called F35. Designer of lift fan for short take-off vertical landing (STOVL) on the...

What are the head and cylinder made of, material wise? Aluminum or steel? Charlie

Will a 38 tooth rear sprocket fit a 2nd generation warrior hub without grinding? I can't seem to find a definitive answer anywhere.... Looks like its no problem on the 1st Gen warriors and banshees, BUT 2nd gen banshee hubs need to be ground down for sure..... Charlie

Which years will swap with a 1989 engine? I have the chance to get a 2004 cheap but I see they are different part numbers!?!? Will it work? Thanks Charlie

Well there is good news....sorry I took so long to get back to you guys... It was the float height issue. The Outlaw carb kit had a slightly and I mean slightly taller needle and seat than what I had before and it was off just enough to not fill the bowl. So after numerous attempts I...

That is exactly where it is!! I was going to ask where to take the measurement on the float that the manual says!?!? And it says before it starts to touch the needle and seat?!?! The picture looks like they are measuring to the top of the float and if that is the case mine is way off...

The drain screw is in tight. I haven't checked the float height yet but it ran perfect and no fuel out of the overflow so I assume it is fine. But I'll check and report back in a minute! Thanks a bunch....:tup: Charlie

Oh and the fuel runs out of the gas tank NO PROB.....must not be the petcock...

ok update..... I have removed the carb again and it didn't have any fuel in the bowl? The needle and seat are working fine and the float height good. What I have noticed is the acceleerator pump is sticking on the float bowl gasket. I couldn't push it back down until I removed the bowl and...