Search results

When it does this and you release the clutch is the reverse lever clicking because sometimes it is hard to get fully back into forward.. if thats the case i usually put it in first release the clutch and then pull the clutch and then put the knob to forward

didnt notice that.. and i just ditched the rear lowering kit in the woods.. it was pissing me off too much

its gone.. i dont care.. not worth it prob would break again soon anyway.. its cheap and not well built

haha i know

yeaa and also i dont think the thing was screwed in all the way so it only had 1 or 2 threads to rip out

haha ill post it there too i guess.. and yea it sucked.. i cant believe a tow rope worked for like hours

well you guys were right, the rear lowering kit was weak. first ten minutes of trail riding with it we had to cross some railroad tracks.. got stuck so lifted on grab bar when we got it over the rear lowering kit was hanging.. it was an adjustable one with threads, the threads pulled right out...

it didnt break from hitting anything it pulled out because we lifted the grab bar

well you guys were right, the rear lowering kit was weak. first ten minutes of trail riding with it we had to cross some railroad tracks.. got stuck so lifted on grab bar when we got it over the rear lowering kit was hanging.. it was an adjustable one with threads, the threads pulled right out...

i agree with tyler

HAHAHAHA that was hilarious!

74.5 MPH tyler... googles an amazing thing..

http://philadelphia.craigslist.org/mcy/1581718758.html

thanks guys and hahaha at beastlywarrior

ok ill try that.. thanks

alright well take some pictures of how you set the spring and deffinetly let me know how it works

isnt the spring really big though?

yea thats why it would only run at full throttle! and pretty sure i sprayed carb cleaner and blew air through all the jets

well ran that carb cleaner.. didnt help.. took it all apart cleaned it up then noticed the black piece (pictured below) that holds the needle was stuck up.. noticed it had some wear on the edges maybe from deterioration due to old gas. filed it a little so it slides up and down better seemed to...

ok ill try that today