Search results

The only problem I've had so far is the first time out in practice it turned the tie rod sleeves into pretzels I looked down after a double and the wheel where pointing two different directions. I had to make thicker, longer sleeves so I can screw in the ends to keep them from bending .

Actually it raises the top of the shock up. I loss some of the angle. I got to get the front end up for sure. It rides really low to the ground. It looks like a tt race bike now. I'm going to the track next Sunday for the last race of the year. I hope I can get them dialed in. I worry about the...

I'm running the 2023 yzf 450 front shocks on my warrior. Yes there long , I added a widing kit and shock relocation kit to fit them. I didn't measure them before I bought them. ☹️. Has anyone used them? I'm looking for adjust ideas on where to start. I'm 5'11 and 240 and racing motocross. So...

Has anyone used a 38mm carb of a TRX 450 on their warrior? I'm seen people use the yzf carb but I found a Honda carb with cable for cheap

My header going into the motor keeps coming loose. Is this a common problem? I've replaced the gasket three times now . I torqued the bolts down to what the manufacturer says on the last two I replaced. It's good for a ride or two then it comes loose again. I even tried torquing it down when...

Sounds like it's backfiring. Could be timing.

I try bleeding them , having to refill the reservoir 6 times. I tried hold it at a angle. I tried gravity feed . I still get nothing. I bought a new master cylinder too just in case. When I pump ,hold and open bleeders I get fluid and no more bubbles . I put on new pads and pushed the pistons in...

I installed new longer front brake lines on my warrior last night and now I have no brakes at all. I filled it brake fluid and started pumping with the bleeders open. I got nothing. I figured it was like a car, which I've done lots of times, it would push the air out and start bringing fluid in...

Does anyone know the o.d of the wolverine intake metal tube? I'm trying to see if I use it for my yfz carb swap. There's also a big tube style I saw but also couldn't find the size of it. I found a 45 mm tube to carb connector but I can't find the size the pipe. Or even if the bolt holes will...

I saw I post about using a raptor 350 intake. You just have to heat it up and stretch it a little to fit.its only like 9 bucks so I may buy it just to try.

Yea I was too. Last time I raced was redbud may moons ago. I was running open a on my banshee. Now my son's jumping in with both feet. He bought himself a warrior. Everyone starts somewhere. It's now my job to make it as fast as I can.

Cool. I'm in Ashtabula. About 15mins. Do you go to any of the harescramble or motocross tracks in that area? I know our is closed but I think there's a few more like briatcliff I think.

What part? How close r u from the pa border?

Does anyone know if the Kodiak 400 or wolverine 350 intake with fit a warrior, bolts holes and oring line up? It would be a much cheaper way to use a yfz 450 carb if that first piece will fit. Then I can go to rubber flange next.

Sweet, thanks

Is it the efi ? If so what did you do with the wires.

Is it the efi version? If so what did u do with the wires

Hello, I'm from ne Ohio. We race motocross, tt , flat track and some harescrambles. We run a 2000 warrior if yfz shocks, diamond front end widening kit, dura blue +6 rear axle total on 50" wide. Kenda front and rear 21-7-10 and 18-11-8 or 20-11-9 depending on what we're doing or Hoosiers.Open DG...

Hello, I'm from ne Ohio. We race motocross, tt , flat track and some harescrambles. We run a 2000 warrior if yfz shocks, diamond front end widening kit, dura blue +6 rear axle total on 50" wide. Kenda front and rear 21-7-10 and 18-11-8 or 20-11-9 depending on what we're doing or Hoosiers.Open DG...

I want to replace the carb on my warrior. When I bought it the whole side where the cable goes in was covered in rust. So I figured, if I need to buy a new one anyway why not go bigger. I've heard a Suzuki 400 carb will work. Also yfz 450 ( but it's a little big) , also a few others. I'm sure...