Search results

anyone? anyone? Beuller?

i'm sure this has been asked a million times and i'm sure someone is going to say this is in the wrong category.. I'm thinking my clutch basket is somewhat shot and in need of replacement.. Does anyone know of any really good aftermarket clutch baskets and kits? i went to the hinsen and...

well actually, as the suspension compresses, the toe-in increases.. the ball joints that actuate the spindles sit below the centerline of the joints attached to the steering shaft. as the suspension is compressed and the outter ball joints are brought closer to the centerline, the wheels will...

do you all think it's too big for a warrior that only has an aftermarket exhaust and k&n airfilter? stock mcpuny is 36mm.. i figure the carburetion of the keihin fcr to be better to the point where even at 39mm, it'll still function better off idle.. anyone have any experience?

Hey guys... this one has me stumped.. i had to replace the tie rods and ball joints on my '03 warrior. the manual says to lift the front wheels up so there isnt any weight on them, then do the subtract B-A thing after rotating 180 degrees, yadda yadda... which i get.. the part i don't get is...

Hey, was wondering if anyone out there had any experience with these. i'd like to re-carb my warrior (2003). i'll put a new exhaust on it as well.. trying to get more power out of it. i'd like to keep the airbox (yes, i'll modify it for additional airflow).. when i've read before, everyone...

i plan on also doing the exhaust, but i already have that picked out so that's the easy part.. the thing with the carb is, everyone seems to really dig the edelbrock, but they're not made any more, so i'm stuck getting them off ebay.. which is fine, but i wasn't sure if there were multiple...

Hello everyone, i'm in need of opinions. just bought a 2003 warrior, it's stock (i believe, though i question the gears because while it accelerates quick, it doesn't seem to have much of a top end, and i know it's supposed to do 60).. anywho, i'm very interested in the edelbrock carbs but not...