Thanks. :)
New bearing carrier with new bearings, seals, spacer.
All installed.
Getting it onto the bike.
Install wheels and check all bolts and nuts.
Man this cool so low. low-rider quad. :)
Install caliper and holes. Will bleed brakes tomorrow.
Skid plate installed.
Tested...
I carefully used a bench grinder with wheel wheel in it and then a hand drill with wheel wheel in it for the splines and the thread. WD40 to clean it as you go and then cleaned it with degreaser. Rubbed a little grease over it to shot rusting again. till I do something with it.
Got my bearing...
Nerf bar nets installed.
Swing arm installed.
Just waiting on the new rear carrier/ bearings, seals, spacer all to turn up. Also rear shock is getting looked at today.
Found a little info about the rear shock in service manual last night.
Installed length:
Standard: 228.5 mm (9.0 in)
Minimum (hard): 220.5 mm (8.7 in)
Maximum (soft): 235.5 mm (9.3 in)
Standard: 15 clicks out*
Minimum (soft): 20 clicks out*
Maximum (hard): fully turned-in position
*From...