Like the title says I popped both lower ball joints on my 1989 warrior and have been looking for used arms. Do the raptor 350 arms fit?
The part numbers look almost the same...
1989 Left Lower Arm 3GD-23570-00-35
2004 Left Lower Arm 3GD-23570-10-00
I have read that the -00- is the revision...
oops.... 250 lbs or so...not too light I know but this thing dives bad.
I did swap them out with another set of Banshee shocks and it is the same, so i guess the shocks are working okay because they feel fine on my banshee.
I'll have to give them a shot in the trails then decide if I am going...
I just added a set of Banshee shocks I got off ebay and they seem like they are really soft....I know from reading on here that they are softer but this seems excessively soft....
When I bounce up and down on like I am riding it the front seems to "dive" more than the back, kinda like its...
I know this is an old listing but......
I have some factory wheels with worn tires from my Warrior available in Jupiter Florida....Where are you in south Florida?
Charlie
Mechanical Engineer for General Electric gas turbine for energy production presently.
Was Pratt and Whitney military jet engine designer in Jupiter Florida for F15, F16, F22 Raptor and JSF Strike Fighter now called F35. Designer of lift fan for short take-off vertical landing (STOVL) on the...
Will a 38 tooth rear sprocket fit a 2nd generation warrior hub without grinding? I can't seem to find a definitive answer anywhere....
Looks like its no problem on the 1st Gen warriors and banshees, BUT 2nd gen banshee hubs need to be ground down for sure.....
Charlie
Which years will swap with a 1989 engine?
I have the chance to get a 2004 cheap but I see they are different part numbers!?!? Will it work?
Thanks
Charlie