hey guys,
im back with more questions. I live in the UK so getting warrior parts is extremely difficult.
i'm looking at getting a clamp on filter. is this the adapter i need -...
ok thanks, i checked the timing which was fine. i also checked vavle clearance and both inlet and exhaust were too tight. so i have adjusted them.
i have a few new jets turning up this week and a carb rebuild kit so hopefully that will sort it.
I dont think its the jets as i have owned the...
Hey guys. me again with ore problems. so my yfm350 warrior has been sitting for about 2 years. after a new battery and a few new elec parts it is finally running. however i have a strange idle issue.
it wont idle properly. sounds like it backfires into the carb and splutters.
if i hold on...
new battery on and now it starts fine, charging volt was 14.4v. left the battery over night and this morning it was reading 12.6v.
hopefully this battery will last longer than the rest
Hey,
I’m new here and found it by searching on google for issue with my 2001 Warrior. I’m from the UK so across the pond from most of you.
My issue is that the battery doesn’t hold it’s charge/not charging/draining.
So I bought a new battery around 6 months ago, quad ran great and...
update: cleaned all the connections i could.
the battery has dropped voltage, when i turn the key the voltage drops 3 volts!. so i put the booster on it in charge mode, supplies about 14v max. when i turn the key it drops to 10.5v. the quad will start just about, for a few seconds the solenoid...
Hey guys, been a stalker on the forums for a while but only recently registered.
I've had a search around and the usual causes of my issue i have replaced/fixed and it hasn't sorted my issue.
So.....
i have a 2001 yfm350 warrior.
1. I couldn't start the quad, i had to pull the clutch...