well, they said that it fit the blaster and banshee. i figured that since they are so similar, that it would fit the warrior. yes and no. you have to modify it to work. first off, the part that goes into the master cylinder bracket needs to be ground down about 1/16-1/8". after that is taken care of, the part that is supposed to hit the plunger on the master cylinder just barely hits the edge of the plunger. first i thought about drilling and tapping new holes on the master cylinder housing, but it only needs to be moved about 1/4". i figured if i grabbed the brake too hard, the bolt going through the new hole would break through and end up creating a slotted hole between the new and old hole. what i ended up doing is i drilled and tapped a hole in the lever, put in a bolt so that it hits the plunger. the other problem that i ran into is that there is no stop on the lever. in other words, if you are riding, the lever will flop so far foward that you can barely reach it. came up with a rubber stop that you cant see so that it stays in place. i'll try to take some pics of everything so that it makes more sense. it doesnt look too nigger rigged. wanted matching levers so it was worth it.