dswwarrior350
Well-Known Member
I while back i bought a Hotcam for my warrior. So far i have enjoyed every minute of it being in. It gave me a great boost in power in all Rpm ranges really. The install was pretty strait forward. Simply take out the old cam, and cam bearing, put a new bearing on the Hotcam, put the cam sprocket on the hotcam, and reinstall. Then adjust you valves to .13mm intake and .15mm exhaust. Hotcams reccomends changing the oil after you reinstall it. Break in was pretty simple too, simply run the cam for 1/2 hour under normal riding conditions, no big hills, just some nice riding. You are not supposed to let the quad idle or stay under 3000 rpm's long while riding it. After the 1/2 hour check the valves and put the back to the specs i listed earlier if you need to. After that you are good to go and ride for a long time. The nicest things about the Hotcam is that you do not have to buy new valve springs, or send in your stock cam, so its a drop in mod that only take a couple hours to do. You dont even need to buy a gasket set or anything. So its about 170 dollars(with required parts) which is cheaper than almost all exhausts for a great HP gain. I hope this review helps alot of people out. Here's a Dyno chart for the power increase.