I have done this with out blaster. It had the ugly ass yellow wheels so we just taped the tires off real good and sanded them, sprayed a coat or two of primer, bunch of light coats of black, and then a few clear coats. They actually turned out fairly well and they are chipping just a little but...
Wow thanks for the post.
Well if its that much ill just leave it for now and if it dies theres still the pull starter.
Im planning on replacing atleast the cable if not check the plates and replace if necessary. Aswell as the lever and clean and lube the perch.
Yeah i dont know if the...
Ok sounds good. Ill look at the manifold when i get the bike out. This project might be delayed a little because i still need to rebuild the blaster so it can be sold. But i still need info on this stuffs to.
Yeah. Whats a good bumper? I kinda like the look of the AC one.
I have a cart on Rockymountain thats over $1000. But i can take off the rims probably and if the axle isnt bent or not bent bad enough then that can be taken off. And theres $150 to take off the pipe... Is the Primary drive...
Yeah. What rims were they? Thinking about just using stock rims, painting them black and throwing some fresh meat on them. And just bend back all the little minor bends on the stocks.
oh yeah. Haha i knew that. I always get our bikes confused. And ill deff. try out his wheels to see. I also found a full set of front and rear with G-force wheels and kenda Klaws for about $400. Is this a good deal? Especially if the ones on ours are bent? And i also found a G-force +2 axle for...
Hello all. New here. We have an 87 warrior that is my step moms and im going to rebuild it for her because im bored. Its pretty beat but has potential. I was planning on just stripping it to bare frame and painting and cleaning and whatnot but dont know for sure. (This is going to be a long post...
Looks alot like my 87. In need of a makeover so the step mom can ride it. Did you just paint the rims? Ours are gold and just look bad... and hows the motor on it?