Starting and Idling issue

Yamaha Raptor 350 & Warrior Forum

Help Support Yamaha Raptor 350 & Warrior Forum:

Madmax

New Member
Joined
Jun 20, 2020
Messages
2
Reaction score
0
Location
Joppa, MD
I have a 1998 Yamaha warrior. The only way I can start it is to popstart it while being pulled, however it will not idle once started. I have to keep revving the gas to keep it going. It rides fine, just cant stop. Any ideas? I am very new to this...
 

Owen03 Warrior

New Member
Joined
Aug 13, 2019
Messages
9
Reaction score
0
I would do a compression test, clean the carb and check the stator to make sure you are within the ohm specs.
 

Madmax

New Member
Joined
Jun 20, 2020
Messages
2
Reaction score
0
Location
Joppa, MD
I have cleaned the carb. Replaced the solenoid. Checked starter motor. Checked battery. I get nothing when I hit the switch. When I jump the solenoid the starter motor runs but doesnt actually start the engine. I will do the conpression test and was just looking into checking the stator. Thank you!
 
Top