TOE_IN ADJUSTMENT
1. Place the machine on a level surface.
2. Measure.
...........................................................
Toe-in measurement steps.
.Mark both front tire tread centers.
. Raise the front end of the machine so that there is no weight on the front tires.
. Fix the handlebar straight ahead.
. Measure thw width between the front marks.
. Rotate the front tires 180 degrees until the marks come exactly opposite.
. Measure the width between the marks that are now at the back of the tires.
. Calculate the toe-in using this formula
Toe-in = the width measured from the back subtracted by the width measured in the front.
Toe-in:
17~27mm(0.67 ~ 1.06)
3. Adjust:
.Toe-in
Adjustment steps:
. Mark both tie-rods.
This reference point will be needed during adjustment.
. Loosen the locknuts (tie-rod end) of both tie-rods
. The same number of turns should be gevin to both tie-rods right and left until the specificvtoe-in is obtained, so that the lengths of the tie-rods will be kept the same.
. Tighten the rod end locknuts of both tie-rods.
hope this helps and you understand it lol
i think when i did it it was like 1/2 in toe in not shure tho, just measure it and you will find out.
