No Throttle Response (after replacing the swing arm bearings)

[Andrew Caryer]

I recently changed the swing arm and axle bearing on my warrior and after I got it put back together it doesn't run well. It still idles but does not react to the throttle (it seems to bog down and then stall when on the throttle but idles well).

Prior to changing the bearings it ran well and had no issues with throttle response, it sat for about a month and half not running while I was waiting for the parts. Replacing the bearings went as usual, a lot of hitting and pounding in order to get the pivot out. After we got it back together it wouldn't react to the throttle. I have since tried re-jetting the carb and tuning it with no luck or any change to the throttle.

I am beginning to think that it is something electrical, any suggestions?


P.S. I also removed the parking brake and those wires have been put together

 

[beastlywarrior228]

Sounds like through that time fuel gummed up
In the carburetor somewhere.