Search results

@Knightriderwarrior01 they are in stock

Works connection makes them but not sure if they are making them for the warrior anymore You could email them and see

drwperformanceatv.com for the best case saver available for the warrior/raptor 350

Well since there was only 1 entry no need to vote so congrats to @velociRAPTOR41 on winning the August 2021 QOTM. I won't be doing anymore QOTM as the interest hasn't been enough to make it worth while anymore.

Time to post up 1 high quality pic of your warrior or raptor 350 to be entered for a chance at winning the QOTM for August 2021. Entries will be accepted from today until Friday the 30th then voting will start and go until August 6th when the winner will be crowned.

I used the stock yfz450 springs I just had the shocks rebuilt & revalved for the extra weight

Congratulations to @gantzmatt for winning the July 2021 QOTM

Time to post up 1 high quality pic of your warrior or raptor 350 for a chance to be the QOTM for July 2021 Entries will be excepted until 5pm June 30th then voting will start and a winner will be crowned on July 7th

Congrats to @98'WarL0rd on winning the June QOTM

Did you put the washer back on the starter idler gear shaft between the gear and curclip

Some updated pics

Time to start entering for the June 2021 QOTM post 1 good high quality pic of your warrior or raptor 350 below entry will be open for 1 week starting today

The one way bearing should free spin the one direction and lock up the other direction and turn the idler gears. Usually if the one way is bad it will either free spin both directions or be locked up tight both directions. And when ever you need to replace the one way bearing you definitely...

When they get grooved like that the basket is garbage and if not replaced will cause issues with shifting and eventually break apart as in your case

Ahh those are pieces of the fingers from the clutch basket it must have imploded at one time

Your best bet is go on partzilla.com and find out what parts are compatible between the 2

Well I can tell you that curclip is from the piston there is 1 on each side of the piston that hold the piston pin in most likely previous owner did a top end rebuild and dropped 1 down in the cases and never bothered to fish it out as for the aluminum peices not sure The washer is most likely...