Search results

Benton, Saline County

Motul Shine and Go Works damn good on plastics.

Grizzly Mint here, all day everyday.

The wife a I. Lil fun on the Ole Zuma

Where You at in Arkansas Warriorgirl?

Honestly the main reason i am a Toyota fan is because they are huge partners with Yamaha. I grew up around all that **** too. In the end i can always appreciate good craftsmanship.

I do like both. But.. I wouldn't say the ONLY good builds. Maybe you just need to get out a lil more and run a nice built 93 cobra through the gears. Or Maybe take a RX7 for a test Drive.

Oh ok, hope you get it runnin smooth tomorrow.

So does it still flood?

IDGAF, I can appreciate any good build, whether it be a built 351w in a mustang or a 2jz swap in a 240z or a yota n40 chassis.

2jz swap!!

Go to your local dealer or the net and get a shindy carb kit for around $20-30, Throw out everything in the kit but the orings,gaskets and float valve. Problem solved. Clean carb first though you dont wanna keep pullin it back off.

Haven't we been through this before? I will never run properly without a good float valve and correct adjustment.

Damn!!!

"Roads? Where we're going we don't need roads."

Don't armor all yer seat. Don't drink downstream from the herd.

I meant 250r's in general lt-250r and honda, along with the tecate. Basically ts been around 20 years since production for most 250 2t.

Before you make your decision, just take a stock banshee in good condition for a ride. You will absolutely fall in love with it. Cant go wrong with them. I do love the 250r's and the lt-500r but all that **** is old and 1993 was the last year for all of those. Yamaha still sold the...

First gear is almost useless its that low. With oem gearing that is.

Float valve Bowl gasket pilot o-ring carb top gasket carb front o-ring Adjust float to spec check for blocked vent line on side of carb Check choke knob freeplay and plunger (may be bent) check drain screw on bowl flush tank and fuel valve (don't want any trash getting into float...