Recent content by supervez007

the front diff was direct fit all yamaha have the same gear ratio only the cup of the cv joint was not exactly the same number of spline change only the cup for a big bear 400 2002-2006 and the front drive shaft need to be shorted . but a front drive shaft of the big bear 400...

i put a big bear 400 2006 front diff in my wolverine 350 1996 change the cup of the cv axle to fit in the bear diff make the wiring and 2 relay for the servo motor and put a switch on the dash with a light to see if he was in 2 or 4wd . cut the front drive shaft and reweld it shorter...

thank you but is for the old model wolverine and big bear old kodiak and grizzly 660 . the 450 have removeable ball joint and newer atv .

dynojet stage 1 hmf black slipon with black vector tip.

i dont want to pay a 200 buck a arm for only a bad ball joint on my quad . i have buy a ball joint from a kodiak 450 and a steel tubing fit with the size of the ball joint cut the welding of the old joint. remove it with a press and put the new with a 11 mm washer made with my steel...

miss a black hmf slipon with vector black tip i have this week and the beast reborn.