ok i got a 98 warrior and the head bolts snapped when I was putting my new exhaust on so i drilled the studs and tapped them but my head cracked on the one side so now its pretty much junk so in search of a new head preferably no drilling or tapping
i need a cam to finish my rebuild. i got the quad put together today started ironing out all the wrinkles let her run a little to seat the rings. Well about 45 seconds into a warm up i hear a pop and she dies.:eek: well long story short i snapped the cam and i am in a bind. this is the last part...
ok, I will try that later on after i get off work. there is a possibility that could of happened the motor was disassembled for a week or so. I did move the clutch cover a good bit cleaning it and such. Any other ideas on it will i am tearing into it would be appreciated. i do know that the...
how far out should the pressure plate be out completely tight with no give flush with the clutch boss or somewhere in between cause i loosened the pressure plate bolts and now i have some clutch had to adjust the cable to get it though
ok so my transmission went in my 02 warrior and i split the cases replaced the trans crank bearings shift forks the whole entire engine was practically replace new piston and rings seals gaskets didn't spare anything well i put the engine back in the warrior yesterday and started reassembly i...
did you pull off the covers and check the timing again after it ran just to double check that maybe the timing didnt get out of whack at some point cause that sounds like a timing issue with the back fire out of the carb either that or a electrical timing issue
carb being clogged up clean it throughly again and see also check your pilot and main jets for sizes maybe someone put a bigger one in at some point and also your needle jet check that and see where the c clip is at should beable to find references through out the forum for the jet sizes and...
ok well not to seem like an ass but did you replace the wiring harness with a new or used i have off days with mine well half days one minute it runs the next it doesnt jiggke the wiring harness it runs fine (i also reran the stock harness till i get a new one) a common place if its used is...