Recent content by Nick

Yamaha Raptor 350 & Warrior Forum

Help Support Yamaha Raptor 350 & Warrior Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. N

    piston stamped 1.00?

    I would assume so I tore mine down to build it and I order a wiseco 12:1 CR piston that was a standard 83mm size and didn’t realize my piston was stamped with 50 and then check measurements and I have a 83.5mm piston and bore
  2. N

    Carb jetting help

    I have a 12:1 CR piston going in I’ve ported the head and I have a slip on exhaust. Wondering what jetting I should be using if anyone has a similar set up. I’ll be adding a cam in a few month web .390 wondering if I need to change again
  3. N

    Need help! Piston and Cam combo

    I live right near an air port and that’s where I get my 112 octane fuel from I’ve used/use it in all on my dirt bikes and race bikes plus I get it for pretty cheap
  4. N

    Need help! Piston and Cam combo

    I already do run race fuel 112 octane. What thanks for the info I’ll replace the hearing now too. But do you think that this combo will work like there won’t be any clearance issues
  5. N

    Need help! Piston and Cam combo

    I have a 1999 warrior 350 here that i am rebuilding and want to build the engine up. So I want to put in the Wiseco 12:1 CR piston and want to do a cam too but I’m un sure if there will be and clearance issues with that set up. Was thinking either hot rod stage 1 or a web .390 and help would be...
Back
Top